LHS-1 Asphalt Moisture Content Tester

Product Information

This tester is suitable for determining the moisture content of petroleum asphalt, coal tar pitch, emulsified asphalt, etc. The asphalt moisture content tester is used to measure the amount of moisture contained in asphalt samples, expressed as a percentage by mass. The applicable standard is JTG3410-2025 "Test Code for Asphalt and Asphalt Mixtures in Highway Engineering"

Main technical parameters:

(1) Glass flask; Made of hard glass, round bottom, short neck, diameter 100mm, volume 500mL.

(2) Moisture receiver; The shape is as shown in the figure, with a volume of less than 0.3mL and a scale of 10 equal parts, a scale of 7 equal parts between 0.3-1mL, and a scale of 0.2mL per division between 1-10mL.

(3) Condenser tube; Straight or spherical, with an inner pipe diameter of 10mm and a total length of 350-400mm, with a beveled end. The sleeve diameter is 40-50mm and the length is 250-300mm. The inlet and outlet of the water pipe are close to both ends

(4) Iron frame; Equipped with iron rings and clamps,

(5) Heater; Electric heating sleeve.

(6) Chassis

(7) Dimensions: 700 * 215 * 340 (mm)

(8) Gross weight: 10Kg